What Are the Common Faults of Instant Hot Water Dispensers

Instant hot water dispenser is a kind of high-tech intelligent innovative water dispenser that is different from traditional water dispensers. Next, we will introduce you to the common faults and solutions of instant hot water dispensers.

What are the functions of the instant hot water dispenser?

• Because it is hot immediately after opening, hot water and cold water are separated, and the function of instantaneous heating of the water will not cause the phenomenon of alternate mixing of cold water and hot water. There will be no stagnant water.

• The water is heated by fluidity, and the instant hot water dispenser without the inner tank is less likely to produce scale. It is enough to clean it once a year, just pour in white vinegar or lemonade and wash it with water.

• Since the hot water comes out immediately, there is no need to keep warm if you want to drink hot water, which saves more power, and the standby power is zero.

• Microcomputer control, intelligent and user-friendly function design, there is a water storage tank that comes with the machine, and bottled mineral water can also be used for heating directly. At the same time, it is equipped with a pumping treasure that can directly extract bottled water, eliminating the need for bottled water to be moved up and down. Trouble. Anti-dry burning, when there is no water in the water tank, the machine will sound an alarm and stop working immediately. Different water output and water temperature can be set to meet different needs in all aspects.

Common faults and solutions of instant water dispensers

Heater light off, no heating

✔️Cause of issue 1: It is caused by the power failure due to the lack of water in the water dispenser during installation.

✔️Approach: disconnect the power supply, open the rear panel, there are 2 thermostats on the side of the hot water tank, one of which is a thermostat with a switch to prevent dry burning, just push the switch inward with a screwdriver; after the switch is reset, power on to check, this is the heating indicator light again, after turning off the power, screw on the back plate.

✔️Cause of issue 2: The reset thermostat is not reset.

✔️Approach:

• Unplug the power plug and cut off the power.

• Wait for the water temperature of the hot tank to drop below 25%, and then press the reset button of the thermostat.

Water dispenser leaking

✔️Cause of issue 1: The float valve of the water purifier is not installed correctly. When the water tank of the water dispenser is full, the float valve fails to stop the water in the lower bucket of the water purifier from flowing down, causing water leakage.

✔️Approach: Reinstall the float valve and test whether it works normally under the tap before placing it on the water dispenser.

✔️Cause of issue 2: The silicone tube in the water dispenser is loose due to transportation.

✔️Approach: Open the rear panel, observe directly or after adding water, observe where the interface leaks. After finding out, use a new or original cable to fit the silicone tube on the interface. Dry the parts inside the water machine with a dry cloth after repairs.

Water dispenser faucet seepage

✔️Cause of issue:

• Whether the handle of the faucet is tightened.
• Whether the handle of the faucet is twisted and twisted.

✔️Approach: Tighten the red or blue part of the faucet clockwise to make the faucet reset and tighten. Or unscrew it counterclockwise first, adjust the silicone tube and spring in the faucet by hand, and then re-screw the faucet; you can also ask the after-sales service personnel to come to the door to replace the handle of the faucet or open the rear panel to replace the entire faucet.

Conclusion

For more information about electric thermo pot water boiler dispenser,thermo pot hot water dispenser,Electric Hot Water Dispenser, we are glad to answer for you.